Difference between revisions of "Electronics written problems II"
Juliesutton (Talk | contribs) (Created page with "Category:20.309 Category:Electronics {{Template:20.309}} __NOTOC__ This is Part 1 of Assignment 7. <br /> ==Measuring action potentials== The [https://en.wikiped...") |
(No difference)
|
Revision as of 16:29, 23 January 2020
This is Part 1 of Assignment 7.
Measuring action potentials
The patch clamp is a technique for measuring voltages produced by electrically active cells such as neurons. One potential problem with the patch clamp technique is that a device must be physically attached to the neuron being measured. Connecting anything to a neuron might alter its behavior. The measurement device itself can distort the signal. This problem of loading the system to be measured affects many kinds of measurements (not just electronic ones). In this problem you will consider a simple model of the distortion in a patch clamp measurement.
A circuit model for a neuron connected to a patch clamp apparatus consists of a time-varying voltage source in series with an output impedance of 1011 Ω. There is an oscilloscope next to the neuron with an input impedance of 106 Ω and an input capacitance of 20 pFd. A new UROP in the lab attempts to measure the electrical spikes produced by a neuron (called action potentials) by connecting the patch clamp apparatus to the oscilloscope with a cable that has a capacitance of 80 pFd. Action potentials are about 100 mV in amplitude and about 1 ms in duration. You can model the noise in the oscilloscope as a random, additive, normally distributed voltage with a standard deviation of 10-3 V.
Easy Bode plots
1 | 2 |
---|---|
3 | 4 |
Harder Bode plots
1 | 2 |
---|---|
Linear systems
1 | 2 |
---|---|
Second-order system
Find the transfer function $ H(\omega)=\frac{V_{out}}{I_{in}} $ for the circuit below. |
- Assignment 7 overview
- Electronics written problems II
- Electronics boot camp lab part 1
Back to 20.309 Main Page.